1. 米兰官网AC Milan

      Techniques for the detection and counting of starch particles in the atmosphere

      Claudio F. Pérez, Soledad Maciel, María Gassmann, Rubén F. Iacono, Mauricio C. De Marzi, Mauro Covi

      Published: 2024-08-16 DOI: 10.17504/protocols.io.n2bvjnzzwgk5/v1
      AI 解读
      浏览 1832

      Abstract

      Suspended particles in the atmosphere (aerosols) can impact visibility, the radiation budget, architectural heritage, agricultural activity, and human health (Pérez et al ., 2020). Recent studies suggest that flour derivatives like starch are present in the environment (de Diego et al ., under revision). This research protocol outlines a list of suitable techniques for detecting and recording the presence of starch in the air.

      Before start

      Carefully wipe all surfaces, materials, and tools with ethanol to avoid any starch contamination during the preparation of samples.

      Steps

      Preparation of the adhesive mixture and mounting media

      1.

      Several recipes are in the literature (eg. Käpylä, 1989). But we recommend the following one.

      20g

      500mL

      500mL

      60rpm

      Weigh 20 g of silicone grease and add to a 1L caramel-colored jar.

      Pour the carbon tetrachloride into the jar and gently shake the bottle by opening the lid from time to time to evacuate any vapors that accumulate inside. Let it rest for a day and repeat the shaking operation. Generally, between 24 and 48 hours of this procedure are required until the silicone is completely dissolved. Once the silicone grease has completely dissolved, fill up with 500 mL of acetone.

      Carbon tetrachloride can be replaced with 500 mL of acetone, although the silicone solubility is lower and the procedure will require more time.

      Note
      This adhesive mixture can be prepared and stored in a cool place. It is useful for studying aerosols using gravimetric or volumetric methods. Depending on the ambient temperature, the solution may appear cloudy. This does not affect its use.

      2.

      The preferred mounting media is glycerine with a small amount of phenol to prevent fungal growth. Store in a bottle.

      50mL

      2mg

      Sampling design

      3.

      Decide what type of sampling to deploy in the field ( fig.1 ).

      Figure 1. Types of sampling methodologies, supporting surfaces, and counting techniques for airborne starch sampling
      Figure 1. Types of sampling methodologies, supporting surfaces, and counting techniques for airborne starch sampling
      4.

      This sampling method is based on the volumetric-isokinetic technique designed by Hirst (1952) which is regularly used in Aerobiology.

      Equipment

      ValueLabel
      7 day recording volumetric spore trapNAME
      Pollen and spore trapTYPE
      BurkardBRAND
      1SKU

      The trap (Burkard Manufacturing Co.) filters air at a constant rate of 0.6 m3 per hour. The aerosols are collected on a sticky Melinex plastic tape (provided by the trap manufacturer) that rotates at a steady speed of 2 mm per hour, allowing for the calculation of hourly and daily concentrations (number of particles per m3). The device faces the wind automatically. The tape is replaced weekly ( Fig. 2 ). Find additional details on the operating process in Burkard's manual.

      Figure 2. Changing the sticky tape of the Burkard pollen and spore trap
      Figure 2. Changing the sticky tape of the Burkard pollen and spore trap
      4.

      This technique relies on gravity to deposit aerosols suspended in the air. We developed a wooden box trap that prevents the repulsion or attraction of aerosols caused by static charges ( Fig. 2, 3 ). The collected material is supported on a coated slide, and the particles enter through a known size slot. The box trap is positioned horizontally without any surrounding obstacles.

      Figure 2. Box trap scheme
      Figure 2. Box trap scheme
      Figure 3. Wooden box trap. (a) Exterior and (b) interior view with the slide
      Figure 3. Wooden box trap. (a) Exterior and (b) interior view with the slide

      Preparation of adhesive surfaces

      5.

      Prepare sticky slides spreading the adhesive mixture with a soft brush. The duration of exposure varies according to the research goals.

      Preparation of adhesive tape

      5.

      After placing the Melinex tape on the rotating drum of the Burkard trap (please refer to the trap's user manual for instructions), it should be coated with the adhesive mixture using a soft brush.

      Preparation of slides

      6.

      Add 5 to 6 drops of mounting media (glycerol + phenol) to each exposed slide, cover them with a clean coverslip, and seal them with nail polish.

      Note
      To increase the fluidity of the mounting medium, it can be gently heated no more than 35 or 40°C in a water bath.

      Preparation of samples

      6.

      The exposed tape should be cut into 7 pieces, each corresponding to a sampled day, using the Perspex cutting block provided by the trap manufacturer ( Fig. 3, 4, 5 ). All the materials and tools to be used should be carefully cleaned with ethanol.

      Figure 3. Exposed Melinex tapes
      Figure 3. Exposed Melinex tapes
      Figure 4. Materials for mounting the slides
      Figure 4. Materials for mounting the slides
      Figure 5. Cutting the 7-day exposed tape
      Figure 5. Cutting the 7-day exposed tape

      Detection and counting of starch particles

      7.

      Samples are studied with an optical microscope with a final magnification of 400 or 1000X according to particle size.

      Equipment

      ValueLabel
      Binocular microscopeNAME
      DM750TYPE
      LeicaBRAND
      1SKU

      Gravimetric samples require inspection of the total surface of the slide. By performing a simple calculation, we can determine the deposition rates in terms of the number of particles per square centimeter over a specific period. The reference area for this calculation is the area of the wooden slot. We performed one-month exposure periods.

      Starch granules appear under the optical microscope as hyaline particles that are difficult to separate from mineral dust like quartz crystals, which are very common in aerosol samples ( Fig. 4 a,c,e ) However, polarized light illumination allows starch to be recognized from a cross-shaped mark ( Fig. 4 b,d,f ) that identifies it among the rest of the aerosols in the sample (Moss, 1976).

      Citation
      Figure 4. Starch granules at 400 x magnification. Reference flour starch without (a) and with (b) polarized light. Starch granules from gravimetric samples without (c) and with (d) polarized light. Starch granules from volumetric samples without (e) and with (f) polarized light. Red arrows show starch granules.
      Figure 4. Starch granules at 400 x magnification. Reference flour starch without (a) and with (b) polarized light. Starch granules from gravimetric samples without (c) and with (d) polarized light. Starch granules from volumetric samples without (e) and with (f) polarized light. Red arrows show starch granules.

      7.

      Each piece of tape should be glued to a clean slide with the Gelvatol solution ( Fig. 6 ). Add the piece of tape to each slide ( Fig. 7 ).

      Figure 6. Coating the slide with Gelvatol solution
      Figure 6. Coating the slide with Gelvatol solution
      Figure 7. Fixing the 1-day piece of tape
      Figure 7. Fixing the 1-day piece of tape

      Note
      Take extreme care not to rotate the daily tape pieces so as not to lose the time sequence of the record.

      7.1.

      Preparing the Gelvatol solution

      35g

      2g

      80mL

      Add the Gelvatol and the phenol to the water and allow it to stand overnight.

      50mL

      100

      The next day, add the glycerol, heat in a water bath (or warm gradually in a microwave), and stir to mix. Use this to prepare the 10% solution. Store tightly covered. It will last a long time.

      7.2.

      10% Gelvatol solution

      2mL

      18mL

      ``

      Add the 2 ml of Gelvatol solution to the distilled water. Shake, stir, or gently heat in a water bath and mix until the Gelvatol completely disperses. Use this 10% Gelvatol solution to attach the 24-hour segments of exposed Melinex tape onto microscope slides.

      Note
      The Gelvatol solution is thick, so it is easier to weigh 2 g instead of measuring 2 ml solution.

      8.

      Add 5 to 6 drops of mounting media (glycerol + phenol) to each slide, cover them with a clean coverslip, and seal them with nail polish ( Fig. 8 ).

      Note
      To increase the fluidity of the mounting medium, it can be gently heated no more than 35 or 40°C in a water bath.

      Figure 8. Putting the coverslip
      Figure 8. Putting the coverslip
      9.

      Samples are studied with an optical microscope with a final magnification of 400 or 1000X according to particle size.

      Equipment

      ValueLabel
      Binocular microscopeNAME
      DM750TYPE
      LeicaBRAND
      1SKU

      Volumetric samples can be analyzed at daily or hourly intervals using the standard technique outlined in Käpylä and Penttinen (1981) for aerobiological samples.

      Starch granules appear under the optical microscope as hyaline particles that are difficult to separate from mineral dust like quartz crystals, which are very common in aerosol samples ( Fig. 9 a,c,e ) However, polarized light illumination allows starch to be recognized from a cross-shaped mark ( Fig. 9 b,d,f ) that identifies it among the rest of the aerosols in the sample (Moss, 1976).

      Citation
      Figure 9. Starch granules at 400 x magnification. Reference flour starch without (a) and with (b) polarized light. Starch granules from gravimetric samples without (c) and with (d) polarized light. Starch granules from volumetric samples without (e) and with (f) polarized light. Red arrows show starch granules.
      Figure 9. Starch granules at 400 x magnification. Reference flour starch without (a) and with (b) polarized light. Starch granules from gravimetric samples without (c) and with (d) polarized light. Starch granules from volumetric samples without (e) and with (f) polarized light. Red arrows show starch granules.

      推荐阅读

      Nature Protocols
      Protocols IO
      Current Protocols
      扫码咨询